Auto Lathe
STM-1525
The mainspindle is made of special steel which also treated by high frequency heat treatment and precision ground, Especially. This machine be installed five sets tools and fine adjusted screw for processing high precision workpiece. As for, the sliding unit is made of high grade cast iron and the sliding surface also be treated by high frequency heat treatment and precision ground.
The unit is adopted magnetic clutch and drived tapping shaft,and the tapping processing is employed the differential speed which generated by high speed rotating in same direction, Especially the two shaft can be swivelled and exchanged processing, reaming, boring deep hole and tapping can be completed simulatneously.
Exterior cutting is employed the plate cam, But the rectangle cutting be used the bell cam and the shaft can be divided into two portion from the central journal. Furthermore, the cam can be retained in original condition and exchanged additionally. Since, the total set be assembled & exchanged within short time, moreover, which can be changed to manual in necessary, high efficiency.
| Modle | STM-1525 |
|---|---|
| No. of tool rack | 5 mm |
| No. of tool unit head | 2 mm |
| Max. processing diameter |  14 mm 10 mm 8 mm |
| Max. processing length | 35 mm |
| Max. drilling dia. | ø10 mm |
| Max. drilling depth | 30 mm |
| Max. tapping dia. | ( Brass ) M10 x 1.25 mm ( Iron ) M8 x 1.0 mm |
| Spindle rev. speed | 1700 ~ 6500 rpm |
| No. of conversion of spindle rev. speed | 5 mm |
| Cam shaft rev. speed | 1.3 ~ 3.3 rpm |
| Spindle motor | 2 HP |
| Cutting fluid pump motor | 1/8 HP |
| Machine weight | 710 kg |
| Machine size | 1450 x 560 x 1540 mm |
| Measurement | 1720 x 740 x 1840 mm |
* Owing to the mechanism be reformed progressively, so that, above mentioned specifications which just for refer. If those are subjected to chachange, without prior notice.
Travel of tools & Interference of tools
